Looking at heating in St Louis near Sunset Hills, we realize that is has been some time since we perused the halls of an HVAC explanation, looking for new details to point out surrounding your system in St Louis. So, today, we stumble upon the heat exchanger. “The heat exchanger is found inside your furnace unit’s housing. This component switches on when the furnace is activated by thermostat to produce warmer temperatures in winter.” The way it operates is to pull in cool air, then heat it and circulate it by way of your ducts and our through your vents.
The heat exchanger pulls in cool air, heats it, and circulates the resulting heated air via your ducts and out through the vents. The evaporator coil is another important heating component to understand. It has, basically, the opposite job of the heat exchanger and it acts to cool the air when the thermostat is set lower and cooler during the summer months. “Located in a metal enclosure on the furnace’s exterior, to the top or side, the evaporator coil works similarly to an automobile radiator to produce cool air, which is then circulated through the ductwork.”
Now, we move onto the condensing unit of your heating and cooling system in St Louis near Sunset Hills. Connected to the evaporator coil, the condensing unit is installed by HVAC contractors on the outside of your home and filled with refrigerant gas in order to properly operate. “When the refrigerant has been cooled to a liquid by heat exchange with the exterior air, the condensing unit pumps the liquid to the evaporator coil to be evaporated into a gas once more.” This leads us to your refrigerant lines which carry the refrigerant substance to the condensing unit vaporized in the form of gas and return it to the evaporator coil in liquid form. In order to be resistant to temperature, these lines are typically made of copper or aluminum.